What is the reverse hack squat?
The reverse hack squat is a hack squat performed facing into the machine: chest against the back pad, shoulders under the pads, feet planted on the platform below you. Turning around changes what the machine asks of you. Instead of a guided, upright quad press, you hinge: the hips travel back and down while the pad carries your torso, which shifts the emphasis from the quadriceps toward the glutes and hamstrings. You get squat-depth loading for the posterior chain with no bar on your spine and no balance demand. That makes it a favourite glute builder on machine leg days, and a smart option when heavy free squats wear your lower back down.
How to do the reverse hack squat
- 1
Face the pad and set your shoulders
Step onto the platform facing the machine: chest against the back pad, shoulders snug under the shoulder pads, hands on the handles. Your body should feel pressed into the machine before the first rep.
- 2
Choose your foot position
Feet hip to shoulder width. Place them higher on the platform to keep the shins vertical and bias glutes and hamstrings; lower lets the knees travel and shifts the work to the quads. The whole foot stays in contact either way.
- 3
Hinge down with the hips leading
Release the safeties, brace, then push the hips back and down for 2-3 s until the thighs reach at least parallel. Heels stay heavy and the chest keeps light pressure on the pad the whole way down.
- 4
Stand up through the heels
Drive the platform away through the whole foot, hips coming forward to meet the pad, and finish tall with the glutes squeezed. Stop just short of slamming the knees into lockout.
Pro tip
The platform is your bias dial: set the feet high and the shins stay vertical, the hips do the work and the glutes take the set; set them low and the knees travel forward and the quads take over. Pick one position per training cycle and progress it, instead of letting your stance drift from week to week.
Common mistakes
Heels floating at the bottom.
Chasing depth past your ankle and hip mobility pulls the heels off the platform and dumps the load onto the knees. Either stop a notch higher, or move your feet higher up the platform; depth only counts while the heels stay planted.
Hanging off the shoulder pads.
At the bottom, a tucking pelvis and a rounding lower back mean the machine is holding you up, not the other way round. Cut the depth to just before the pelvis rolls under and keep the trunk braced against the pad.
Knees collapsing inward on the way up.
Fatigue drags the knees toward each other, especially with a glute-biased stance. Screw the feet into the platform and drive the knees out over the toes; if they still cave, the load is too heavy for today.
Riding the bounce out of the hole.
Dropping fast and reversing off the machine's spring gives you a bigger number and a smaller stimulus. Own the 2-3 s descent, arrive at the bottom quietly, and drive up from a dead position.
Variations and progressions
Easier
Leg press
The seat carries your whole back and the hinge disappears: you just press. The simplest way to load the legs heavy while you build the mobility and control the reverse hack demands.
Harder
Barbell back squat
Take away the pad and the rail and your trunk must do everything the machine was doing. Same depth, same hinge, with balance, bracing and bar control added to the bill.
Alternative
Machine hack squat
Turn back around: back against the pad, torso upright, knees travelling far forward. The front-facing version is the quad builder; run both across a training week for complete legs.
How to program it
Three protocols by goal. Pick one per cycle and aim for progression on load or distance.
| Goal | Sets × distance | Load | Rest |
|---|---|---|---|
| Strength | 4 × 6-8 | RPE 8 | 2-3 min |
| Hypertrophy | 3-4 × 8-12 | RPE 8 | 90 s to 2 min |
| Glute volume | 3 × 12-15 | Moderate, 1 s pause at depth | 90 s |
Reverse Hack Squat FAQ
Hack squat vs reverse hack squat: what changes?
The direction you face, and with it the joint that does most of the work. Facing out, your back rests on the pad, the torso stays upright and the knees travel: a quad press. Facing in, your chest is on the pad and your hips are free to hinge back: glutes and hamstrings pick up a much bigger share. Same machine, two different leg exercises.
Is the reverse hack squat good for glutes?
One of the best machine options there is. It loads the glutes through deep hip flexion, supports the torso so the lower back is not the limiter, and lets you add weight in small jumps for years. Set the feet high on the platform, hit full depth with the heels down, and finish every rep with a deliberate hip squeeze.
Can I do it on any hack squat machine?
On most plate-loaded ones, yes: step in facing the pad and check that your shoulders fit under the pads and your knees clear the frame at depth. Geometry varies between brands, so take a rep with an empty sled first. If your gym has a V-squat or pendulum squat machine, those are built for this exact facing-in pattern.
How deep should I go on the reverse hack squat?
As deep as you can while two things stay true: heels pressed into the platform and pelvis not tucking under. For most people that lands at or below parallel, deeper than they squat with a bar. The supported torso is the whole point of the machine, so use the range, just never borrow it from your lower back.




