What is the wide grip bench press?
The wide grip bench press is a barbell bench variation with the hands set clearly wider than standard, typically index fingers on or just inside the rings (competition rules cap the grip at 81 cm). Widening the grip shortens the range of motion, keeps the elbows more abducted, and shifts work away from the triceps toward the pectorals and front delts. Powerlifters use it to shorten the stroke and lift more; physique-focused lifters use it to bias the chest. The cost is a reduced margin for error at the shoulder, so setup and gradual progression matter more here than on a standard bench.
How to do the wide grip bench press
- 1
Find your width
Set your index fingers on the power rings, or one finger-width inside if this grip is new to you. At the bottom of the rep, your forearms should be vertical when viewed from the front.
- 2
Lock the shoulder blades
Pinch the shoulder blades back and down, plant the feet, keep a modest arch. The wider grip gives the shoulders less slack, so this setup is non-negotiable.
- 3
Lower to the nipple line
Unrack and bring the bar down under control to the nipple line or slightly above, elbows at roughly 70-80 degrees from the torso, never in a straight line with the shoulders.
- 4
Press up and slightly back
Touch the chest softly, then drive the bar up toward a point over the shoulders, keeping the blades pinned to the bench for the whole rep.
Pro tip
Earn the width. Move your grip out one finger-width per week while keeping the same bar speed and a soft touch on the chest. Jumping straight from standard grip to the rings with your usual working weight is how this variation got its bad reputation.
Common mistakes
Elbows flared to 90 degrees.
Elbows in line with the shoulders at the bottom put the shoulder joint in its most vulnerable pressing position. Keep them around 70-80 degrees, tucked just enough that the forearms stay vertical.
Bouncing off the chest.
The shortened range tempts you into heavier loads and a bounce through the sticking point. A bounced wide-grip rep sends the shock straight into pecs and shoulders at full stretch. Touch, pause a beat, press.
Losing the scapular set.
If the shoulders roll forward as the bar touches, the pec stretch turns into joint strain. End the set when you can no longer keep the blades pinched.
Keeping your standard-grip loads.
Most lifters press a bit less with a wide grip, at least at first. Start around 90% of your usual working weight and let the numbers come back on their own.
Variations and progressions
Easier
Wide-grip push-up
Hands set outside shoulder width on the floor. Learn the elbow angle and the pec stretch with bodyweight before loading a bar.
Harder
Paused wide-grip bench
A full 2-second pause on the chest removes every trace of bounce and forces the pecs to produce force from a dead stop in their most lengthened position.
Alternative
Dumbbell bench press
If the wide grip bothers your shoulders, dumbbells give a similar pec stretch while letting each arm find its own path and angle.
How to program it
Three protocols by goal. Pick one per cycle and aim for progression on load or distance.
| Goal | Sets × distance | Load | Rest |
|---|---|---|---|
| Strength | 5 × 3-5 | 80-87 % 1RM | 3 min |
| Hypertrophy | 4 × 6-10 | Moderate to heavy | 2 min |
| Paused technique work | 3 × 5, 2 s pause | ~70 % 1RM | 2-3 min |
Wide Grip Bench Press FAQ
Is the wide grip bench press better for chest?
It shifts the balance toward the pecs. With the hands wider, the elbows flex less, so the triceps contribute less and the pecs and front delts pick up the difference. That makes it a useful chest-emphasis press, not a mandatory one: a standard bench plus flyes covers similar ground. Use it if your triceps keep cutting your bench sets short.
How wide is too wide?
Competition rules cap the grip at 81 cm between the index fingers, which is the rings on a powerlifting bar. Mechanically, stop where your forearms are vertical when the bar touches the chest: past that point you lose pressing leverage and pile stress on the shoulders and pecs for no extra benefit.
Is wide grip benching bad for the shoulders?
Not inherently, but the margin for error shrinks. The wider grip holds the shoulder in more abduction, so a lost scapular set, a hard bounce or a sudden jump in width can irritate it. Keep the blades pinned, progress the width gradually, and leave this variation out while rehabbing any shoulder issue.
Will the shorter range of motion hurt my gains?
The bar travels less, but the pecs still reach a deep stretch at the chest, and that stretch is what the range-of-motion debate is really about. You lose a little triceps work, not chest stimulus. If triceps size matters to you, pair it with a close-grip press or dips in the same week.




