What is the cable preacher curl?
The cable preacher curl pairs a preacher bench with a low pulley instead of a free bar. The pad still locks your upper arms in place, but the cable changes the resistance profile: where a barbell version loses almost all tension once the forearms pass vertical, the cable keeps pulling against the biceps through the entire arc, including the squeeze at the top. That constant tension, combined with the rigour the pad imposes, makes it one of the most honest biceps movements available. The setup is worth the effort for lifters chasing hypertrophy who find the top half of barbell preacher curls empty.
How to do the cable preacher curl
- 1
Line up the bench
Place a preacher bench about a metre in front of a low pulley, facing the stack, with a straight or EZ attachment clipped on. The cable should run up to your hands at an angle, not straight down.
- 2
Set your arms, then grab
Armpits over the top edge, upper arms flat on the pad. Grab the attachment palms up at shoulder width, with light tension already in the cable at the bottom.
- 3
Curl against the cable
Flex the elbows and bring the bar toward your shoulders. Notice that the cable still pulls hard at the top: hold that squeeze for a full second.
- 4
Lower without letting the stack land
Control the descent on a slow three-count until the elbows are nearly straight, then reverse just before the plates touch so tension never disappears.
Pro tip
The distance between the bench and the pulley is your resistance curve. If the cable goes slack anywhere in the rep, slide the bench back until it stays taut from full stretch to full squeeze.
Common mistakes
Resting the stack between reps.
Letting the plates land resets tension to zero and turns the set into a series of singles. Reverse a centimetre before they touch.
Bench parked too close.
Sat right on top of the pulley, the cable pulls straight down and the top half of the rep goes empty, exactly what you came here to fix. Back the bench up.
Leaning back to finish reps.
Pulling the torso away from the pad shortens the cable without the biceps doing any more work. Chest stays pressed into the bench, armpits hooked on the edge.
Variations and progressions
Easier
Standing cable curl
Same constant tension without the bench setup. Slightly less strict, but much faster to get into and easy to load precisely.
Harder
Single-arm cable preacher curl
A D-handle and one arm at a time. You can rotate into full supination at the top, and no strong arm covers for the weak one.
Alternative
Bayesian cable curl
The mirror image: standing, facing away from the pulley, arm stretched behind you. It loads the biceps long head at length instead of pinning the shoulder forward.
How to program it
Three protocols by goal. Pick one per cycle and aim for progression on load or distance.
| Goal | Sets × distance | Load | Rest |
|---|---|---|---|
| Hypertrophy | 3-4 × 10-12 | Moderate | 90 s |
| Constant-tension sets | 3 × 12-15, 1 s squeeze | Light to moderate | 60 s |
| Strict strength | 4 × 6-8 | Heavy, cable always taut | 2 min |
Cable Preacher Curl FAQ
Cable or barbell preacher curl, which builds more biceps?
Both are strict, stretch-focused curls, and with matched effort the growth difference is small. The cable wins on tension through the top half and on joint comfort for most people. The barbell wins on simplicity and raw loading. If your gym layout allows the setup, the cable version is the nicer hypertrophy tool.
What if my gym has no preacher bench near the cables?
Set an adjustable bench at roughly 60 degrees in front of the pulley, face the backrest, and hang your upper arms over the top with your chest against the pad. It is a spider-curl setup rather than a true preacher, but it braces the arms the same way and works with any cable station.
Which attachment should I use?
An EZ cable bar is the default: the wrists sit comfortably and both arms work together. A straight bar adds a bit more supination, and a single D-handle lets you train one arm at a time to fix imbalances. Skip the rope here, it turns the movement into a hammer curl.




